10. Use “Diagnostic Tool” to set the media sensor type and calibrate the selected
sensor. (Start the “Diagnostic tool” Select the “Printer Configuration” tab
Click the “Calibrate Sensor” button) Please refer to the section 4.
Note:
Please calibrate the gap/black mark sensor when changing the media.
When the printer is out of ribbon or label, the ON-LINE LED will not come
on and the ERROR LED will flash. Reload the ribbon or media without
turning off the printer. Press the FEED button a few times until the ON-
LINE LED illuminates, the printing job will be resumed without data loss.
Please refer to videos on TSC YouTube or driver CD.
To Next Page
Loading...
Need help?
General
