3.1.1-1.1 Speed:
Use this option to setup print speed. Each increment/decrement is 1 ips. Printer
default density is 6 ips (203 dpi) or 4 ips(300 dpi).
Press key to raise the print speed, and press key to decrease
print speed. Press key to set it into printer. Press key to
cancel the setting and return to the previous menu.
Note: If printing from enclosed software/driver, “Use current printer settings”
option is not selected, the software/driver will send out the SPEED
command, which will overwrite the setting set from the front panel.
3.1.1-1.2 Density:
Use this option to setup printing darkness. The available setting is from 0 to 15
levels, and the increment is 1 level. Printer default density is 8.You may need to
adjust your density based on selected media/ribbon.
Press and to increase/decrease the printing darkness. Press
key to enable the setting. Press key to cancel the setting and
return to the previous menu.
Note: If printing from enclosed software/driver, the “Use current printer
settings” option is not been used, software/driver will send out the
DENSITY command, which will overwrite the setting set from the front
panel.
3.1.1-1.3 Direction:
The direction setting value is either 1 or 0. Use this option to setup the printout
direction. Printer default printout direction is DIRECTION 0.
To Next Page
Loading...
Need help?
General
