TSC TTP-268M

42
3.1.2 Sensor
Sensor
Exit
Status
Calibration
3.1.2.1 Status
This function is available to check the printer’s sensor status. When enter the [Status]
option, you will see following message.
3.1.2.2 Calibration
This option is used to set the media sensor type and calibrate the selected sensor. We
recommend to calibrate the sensor before printing when changing the media.
Calibration
Exit
↓
Exit
Pre-Printed
Exit
↓
Pre-Printed
↓
↓
Manual
Manual
Manual
↓
↓
↓
↓
Automatic
Automatic
Automatic
Exit
↓
↓
↓
Gap Mode
Bline Mode
Cont. Mode
Paper Len.
812
Gap Size
24
Intensity
3
Ref. Level
512