Press key to set the direction as 1, and to set it as 0, and
key to enable the setting. Press key to cancel the setting and
return to the previous menu.
The following 2 figures are the printouts of DIRECTION 0 and 1 for your reference.
Note: If printing from enclosed software/driver, the software/driver will send
out the DIRECTION 0 command, which will overwrite the setting set
from the front panel.
3.1.1-1.4 Print Mode: (None/Batch Mode/Peeler Mode/Cutter Mode/Cutter Batch)
This option is used to set the print mode. Printer default setting is Batch Mode.
When enter this list, the print mode in the right side of “ >” icon is the printer current
setting. Press and to select the different print mode and press
button to enable the setting. Press key to cancel the setting
and return to the previous menu.
Next label top of form is aligned to the print head burn line
location. (Tear Off Mode)
Once image is printed completely, label gap/black mark will
be fed to the tear edge for tear away.
Enable the label peel off mode.
To Next Page
Loading...
Need help?
General
