Enable the label peel off mode.
Enable the label cutter mode.
Cut the label once at the end of the printing job.
This item is used to fine tune media stop location. Available setting
value is from “+” to “-” or “0” to “9”.
This item is used to fine tune print position. Available setting value is
from “+” to “-” or “0” to “9”.
This item is used to set the origin of printer coordinate system
horizontally and vertically. Available setting value is from “0” to “9”.
Use this item to set the code page of international character set.
Use this option to set the country code.
Note: If printing from enclosed software/driver, the software/driver will send out the
commands, which will overwrite the settings set from the panel.
To Next Page
Loading...
