Instrument Operation 5-5
is especially important to use diffusion loss correction when sizing aerosols
<100 nm because diffusion becomes increasingly important in this size.
Note: While it is possible to toggle corrections on and off when viewing a
completed scan, the correction must be on before the sample is
initiated in order for the exported data to use the correction.
Error Messages
The wrench icon indicates an error or warning. Touch the wrench icon to see
an on-screen message describing the error and/or warning state(s).
Table 5-2 contains a brief description of the possible error messages.
Figure 5-1
Electrostatic Classifier Error Screen
(continued on next page)
To Next Page
Loading...
