TSI Instruments 3082 - Cleaning the DMA Electrodes; Long DMA: Cleaning the Electrodes (Shown with 3081 Base Plate)

Maintenance, Service, and Troubleshooting 6-13
Cleaning the DMA Electrodes
W A R N I N G
High-voltage is accessible within this instrument. Unplug the power
source before removing the cover to perform maintenance procedures.
Unplug the high-voltage cable from the classifier to the DMA before
disassembling the DMA or performing maintenance procedures.
Cleaning the Long DMA Electrodes
During cleaning procedures, refer to Figure 6-1 below.
Figure 6-1
Long DMA: Cleaning the Electrodes (shown with 3081 base plate)