6. SPECIFICATION OF INPUTS AND OUTPUTS
6.1.4 Characteristics
For the whole Vision 307 family.
Symbol Parameter Note Min Typ Max Unit
CBAT+ Capacitance load at input 700 µF
V
BAT+
Supply voltage for full operation 1 8 32 V
V
BAT+
Supply voltage for CPU operation 2 6 32 V
T
rise
Supply voltage rise time 3 3 s
Note 1 Display with full backlight brightness
Note 2 Ultra low voltage operation during cranking, the display backlight may be turned off if
V
BAT+
< 8 V
Note 3 The time it takes for V
BAT+
to get higher than 8 V
6.1.4.1 Vision 307
Supply current characteristics for the Vision 307 device.
Symbol Parameter Note Min Typ Max Unit
I
BAT+ idle
Supply current at V
BAT+
= 8 V 1 1000 1100 mA
I
BAT+ idle
Supply current at V
BAT+
= 12 V 1 650 mA
I
BAT+ idle
Supply current at V
BAT+
= 24 V 1 350 mA
I
BAT+ STBY
Standby supply current at V
BAT+
= 12 V, 25
○
C 2 110 µA
Note 1 Idle mode refers to an operational state where there are no external loads, i.e., the Linux
command line runs with no additional application or CPU-/GPU-load.
Note 2 Terminal 15 is off, device is shut down, and RTC capacitor is fully loaded
© TTControl GmbH 2024. All rights reserved.
Proprietary Information
17
Document Number:
D-156-G-02-003
To Next Page