REFERENCES
References
[1] ISO. ISO 11783-2:2012(E), Tractors and machinery for agriculture and forestry – Serial control and communications
dataF network – Part 2: Physical Layer (2nd ed.). International Standard, International Organization for Standard-
ization (ISO), 2012.
[2] TTControl GmbH. Vision 307 Mounting Requirements Document. D-156-G-20-021.
[3] TTControl GmbH. Vision 307 Open Source License Information. D-156-G-20-017.
[4] TTControl GmbH. Vision 307 Product Drawing. D-156-C-02-056.
[5] TTControl GmbH. Vision 307 Quick Start Guide, C Programming. D-156-G-02-004.
[6] TTControl GmbH. Vision 307 Quick Start Guide, CODESYS. D-156-G-02-005.
[7] TTControl GmbH. Vision 307 Summary Test Report. D-156-TR-02-012.
Referenced norms and standards
Documement
no.
Rev. Document title
ISO 16750-1 2006 Road vehicles — Environmental conditions and testing for electrical and elec-
tronic equipment — Part 1: General
ISO 16750-2 2012 Road vehicles — Environmental conditions and testing for electrical and elec-
tronic equipment — Part 2: Electrical loads
ISO 16750-3 2012 Road vehicles — Environmental conditions and testing for electrical and elec-
tronic equipment — Part 3: Mechanical loads
ISO 16750-4 2010 Road vehicles — Environmental conditions and testing for electrical and elec-
tronic equipment — Part 4: Climatic loads
ISO 16750-5 2010 Road vehicles — Environmental conditions and testing for electrical and elec-
tronic equipment — Part 5: Chemical loads
CISPR 25 2016 Vehicles, boats and internal combustion engines — Radio disturbance char-
acteristics — Limits and methods of measurement for the protection of on-
board receivers
ECE R10
Rev.05
2014 Uniform provisions concerning the approval of vehicles with regard to elec-
tromagnetic compatibility
ISO 11452-1 2015 Road vehicles — Component test methods for electrical disturbances from
narrowband radiated electromagnetic energy — Part 1: General principles
and terminology
ISO 11452-2 2004 Road vehicles — Component test methods for electrical disturbances from
narrowband radiated electromagnetic energy — Part 2: Absorber-lined
shielded enclosure
ISO 11452-4 2011 Road vehicles — Component test methods for electrical disturbances from
narrowband radiated electromagnetic energy — Part 4: Harness excitation
methods
ISO 11452-5 2002 Road vehicles — Component test methods for electrical disturbances from
narrowband radiated electromagnetic energy — Part 5: Stripline
© TTControl GmbH 2024. All rights reserved.
Proprietary Information
45
Document Number:
D-156-G-02-003
To Next Page