TTControl Vision 307 - Analog Video Input; Pinout; Functional Description; Maximum Ratings

6. SPECIFICATION OF INPUTS AND OUTPUTS
6.11 Analog video input
6.11.1 Pinout
Connector Pin no. Note Function
C1 8 Video 1 Signal
C1 16 Video 1 GND
C1 6 Video 2 Signal
C1 14 Video 2 GND
C1 29 1 Video 3 Signal
C1 31 1 Video 3 GND
C1 21 1 Video 4 Signal
C1 22 1 Video 4 GND
Note 1 Only available for Vision 307Plus products.
6.11.2 Functional description
The Vision 307 is compatible with PAL B/G/H/I/D (standard PAL) and NTSC-M (standard NTSC) composite
video signals (CVBS). The standard for use with the device can be selected in the application configuration.
Up to four video sources can be displayed simultaneously. All four video sources will be configured for use
with the selected standard.
6.11.3 Maximum ratings
Symbol Parameter Min Max Unit
V
in
Video in permanent (DC) input voltage -1 33 V
6.11.4 Characteristics
Symbol Parameter Min Max Unit
V
in
Video in voltage level 0.5 2 V
pp
6.11.5 General advice
To avoid noise on the video signals, the following is highly recommended:
• use 75 Ω shielded coaxial cables (RG59, RG179 or likewise – depending on cable length)
• minimize connector and junction count
• use separate cable harnesses for the video signals and camera supplies
© TTControl GmbH 2024. All rights reserved.
Proprietary Information
29
Document Number:
D-156-G-02-003