REFERENCES
ISO 11783-2 2018 Tractors and machinery for agriculture and forestry — Serial control and com-
munications data network — Part 2: Physical layer
ISO 10605 2008 Road vehicles — Test methods for electrical disturbances from electrostatic
discharge
ISO 7637-2 2011 Road vehicles — Electrical disturbances from conduction and coupling —
Part 2: Electrical transient conduction along supply lines only
ISO 7637-3 2016 Road vehicles — Electrical disturbances from conduction and coupling —
Part 3: Electrical transient transmission by capacitive and inductive coupling
via lines other than supply lines
IEC 60068-2-1 2007 Environmental testing — Part 2-1: Tests — Test A: Cold
IEC 60068-2-2 2007 Environmental testing — Part 2-2: Tests — Test B: Dry heat
IEC 60068-2-6 2007 Environmental testing — Part 2-6: Tests — Test Fc: Vibration (sinusoidal)
IEC 60068-2-14 2009 Environmental testing — Part 2-14: Tests—Test N: Change of temperature
IEC 60068-2-27 2008 Environmental testing — Part 2-27: Tests — Test Ea and guidance: Shock
IEC 60068-2-30 2005 Environmental testing — Part 2-30: Tests — Test Db: Damp heat, cyclic (12
h + 12 h cycle)
IEC 60068-2-31 2008 Environmental testing — Part 2-31: Tests — Test Ec: Rough handling
shocks, primarily for equipment-type specimens
IEC 60068-2-64 2008 Environmental testing — Part 2-64: Tests — Test Fh: Vibration, broadband
random and guidance
IEC 60068-2-78 2012 Environmental testing — Part 2-78: Tests — Test Cab: Damp heat, steady
state
ISO 20653 2013 Road vehicles — Degrees of protection (IP code) — Protection of electrical
equipment against foreign objects, water and access
EN 13309 2010 Construction machinery. Electromagnetic compatibility of machines with in-
ternal power supply
EN 62262 2002 Degrees of protection provided by enclosures for electrical equipment
against external mechanical impacts (IK code)
EN 55025 2016 Vehicles, boats and internal combustion engines. Radio disturbance charac-
teristics. Limits and methods of measurement for the protection of on-board
receivers (IEC/CISPR 25:2016)
ISO 13766-1 2018 Earth-moving and building construction machinery — Electromagnetic com-
patibility (EMC) of machines with internal electrical power supply — Part
1: General EMC requirements under typical electromagnetic environmental
conditions
ISO 13766-2 2018 Earth-moving and building construction machinery — Electromagnetic com-
patibility (EMC) of machines with internal electrical power supply — Part 2:
Additional EMC requirements for functional safety
ISO 4892-3 2016 Part 3: Fluorescent UV lamps
ISO 14982 2009 Agricultural and forestry machines — Electromagnetic compatibility — Test
methods and acceptance criteria
© TTControl GmbH 2024. All rights reserved.
Proprietary Information
46
Document Number:
D-156-G-02-003
To Next Page