Tunstall ConnectCall - Page 22

ID
Description
Group
Save Exit
Figure A.19
Enter the ID of the fob by using the numeric keypad; only enter the group of 5 digits. Once the ID has
been entered, press the OK button.
ID :
_ _ _ _ _
Clear
OK Exit
Figure A.20
Next assign a description of who the fob will be assigned to. This is a numeric description generally
the flat number. Use the SCPs keypad to enter a numeric description up to a maximum of 5 digits.
Once the description is entered press the OK button.
Description
_ _ _ _ _
Group
OK Exit
Figure A.21
Now we must assign the fob to a group. The group the fob is assigned to decides which doors the fob
can release. The groups are pre-set at the time of installation and are recorded by the installation
team in the back of this manual.
When group is selected from the SCP menu, it is possible to scroll through the groups which are
referenced as a numeric value, when the correct group is selected press the OK key.
Group
1
>
OK Exit
Figure A.22