Tunstall ConnectCall - IP DECT Phone System Operations

Listening to call waiting using the LRH phone
If you hear a background beep when using the handset, an alarm call may be waiting, finish your call
by hanging up and the waiting alarm call will be sent to the handset.
Activate door entry lock release using the LRH phone
If you receive and select a call from the door panel, press 7 then # to open the door
Single/Multiple Tunstall IP DECT phone system
The DECT phones are connected to the system via an IP PABX.
Switching off-site using the IP DECT phone
 Take the phone off hook by pressing , then dial the system number 6060
 Listen to the message - it will ask you to enter the resident number followed by *
 Press 2 followed by #
 Listen to the message ‘system off-site’
 Then hang up
Switching on-site using the IP DECT phone
 Take the phone off hook by pressing , then dial the system number 6060
 Listen to the message - it will ask you to enter the resident number followed by *
 Press 1 followed by #
 Listen to the message ‘system on-site’
 Then hang up
Answering an alarm call using the IP DECT phone
 Press  when the phone rings
 Listen to the full spoken alarm message. If necessary, make a note of the alarm details before
selecting the alarm call
 Press * to select
 Speak to resident
 Press 0 to clear the alarm call and then hang up
NOTE: Failure to follow these steps fully and in order may result in the loss of important
information about the source of the call.
Calling a resident using the IP DECT phone
 Take the phone off hook by pressing , then dial the system number 6060
 Listen to the message - it will ask you to enter the resident number, followed by *
 Enter the resident number followed by * e.g. 3 0 2 *
 Speak to the resident
 Press 0 to clear and then hang up