31
Epilepsy Sensor
After unlocking the Universal Sensor and entering “Select Mode” navigate the menu
using the “Up Button” and or “Down Button”
When “Epilepsy” is highlighted press the “Select Button”
The Universal Sensor will confirm it is now configured to be used
with a 3
rd
part device as an Epilepsy Sensor.
Suggested Configuration: this can be changed using “Advanced Mode”.
Contact Type NO
Input Channel 1
Cable Connection Specialised 3
rd
party cable into the RJ11
The Universal Sensor can now be connected to a 3
rd
party device which is going to be
used as a Epilepsy Sensor and the Tunstall Home unit. Tunstall recommends
completing a test call before leaving the property.
The Universal Sensor has a specific interface to ensure compatibility with Abilia
Epilepsy Control Units (and their associated sensing pads). It is therefore only
compatible with this item (number D-1090).
To Next Page
Loading...