18 INFO MODE
Updating the Software
From the Oven Off screen,
1. Insert the smart card (see Figure 21).
If multiple smart cards are required, ensure
the correct smart card is loaded first.
2. From the
COOLING DOWN or OVEN OFF
mode, press and hold the Info key until the
oven resets (approximately 5 seconds).
3. When the oven beeps one long high tone,
the load was successful. If a second card
was provided, insert it.
4. When the oven restarts and the display
turns on, the update is complete. Remove
the smart card.
NOTE: If the update is unsuccessful, the
display will remain off and the oven will beep
one long, low tone. If this occurs, repeat the
above procedure. If the update fails multiple
times, a smart card may be damaged. Contact
TurboChef to obtain a new smart card.
Figure 21: Inserting Smart Card/USB Device
Smart Card
USB Port
Smart Card Reader Slot
To Next Page
Loading...
Need help?
General
