V01.00 | 2019/12
17
6 Mounting
The device can be mounted on a DIN rail according to EN 60715 (TS35) or screwed onto a flat
mounting plate.
6.1 Mounting the device onto a mounting plate
Attach the device to the mounting plate with two M4 screws. The maximum tightening
torque for the M4 screws is 1.3 Nm
Avoid mechanical stresses.
Optional: Ground the device.
44.5 [1.75]
M4 (2x)
max. 1.3 Nm
Fig.5: Mounting the device onto a mounting plate
6.2 Mounting the device onto a DIN rail (TS35)
Fasten the module or module composite to to the mounting adapter (FDN20-BKT-DIN)
with two M3 screws according to the following figure.
Fig.6: Mounting the device with mounting adapter on DIN rail
Place the device with the mounting adapter on the DIN rail so that the mounting adapter
encloses the DIN rail (1).
Avoid mechanical stresses.
Optional: Ground the device.
To Next Page
Loading...
