V01.00 | 2019/12
19
7 Connecting
7.1 Connecting the device to Ethernet
For connection to Ethernet, the device has an autocrossing switch with two RJ45 Ethernet sock-
ets.
Fig.8: RJ45 sockets for Ethernet connection
Connect the device to Ethernet according to the pin assignment.
12345678
1 = TX +
2 = TX –
3 = RX +
4 = n.c.
5 = n.c.
6 = RX –
7 = n.c.
8 = n.c.
Fig.9: Ethernet connectors – pin assigment P1 and P2
7.2 Connecting the supply voltage
For the connection to the power supply, the device has a 3-pin screw terminal. The maximum
tightening torque is 0.5 Nm.
Fig.10: Terminal connector for connecting the supply voltage
Connect the device to the power supply according to the pin assignment shown below.
1 =
2 = V1 –
3 = V1 +
1 2 3
Fig.11: Pin layout of the Ethernet connections
To Next Page
Loading...
