turck FEN20-4IOL - Technical Data

Technical data
126
Hans Turck GmbH & Co. KG | T +49 208 4952-0 | F +49 208 4952-264 | more@turck.com | www.turck.com
15 Technical data
Technical data
Power supply
Power supply 24 VDC, from V1, Class 2 power supply unit
necessary
Permissible range 18…30 VDC
n IO-Link n 20,4 ... 28.8 VDC
Total current max. 4 A per voltage group
V1 + V2 max. 5,5 A at 70 °C per module
Operating current 100 mA
V2: min.10 mA, max. 115 mA
Sensor/actuator supply Supply from terminal V1+
1
…V1+
4
,
max. 1 A per screw terminal, total max. 4 A
Potential isolation 500 V galvanic zone-zone and zone-ethernet,
voltage proof up to 500 VDC
Connectors
Ethernet
Power supply Terminal screw connector, 3-pole
IO-Link, digital in-/outputs Screw connection, 10-pole terminal connec-
tion, tightening torque max. 0.5 Nm
System data
Transmission rate 10 Mbps, 100 Mbps, full/half duplex,autonego-
ciation, autocrossing
Fieldbus connection technology 2 × RJ45
Protocol detection Automatic
Web server 192.168.1.254 (default)
Service interface Ethernet
Field Logic Controller (FLC)
Supported from firmware version 1.0.11.0
Released as of ARGEE version 1.0.10.0
Modbus TCP
Address assignment Static IP, DHCP
Supported Function Codes FC1, FC2, FC3, FC4, FC5, FC6, FC15, FC16, FC23
Number of TCP connections 6
Input data max. 1 register
Input register, start address 0 (0x0000)
Output data max. 1 register
Output register, start address 2048 (0x0800)
Local port Port 502, fix setting
EtherNet/IP
Address assignment according to EtherNet/IP standard
Device Level Ring (DLR) Supported
Quick Connect (QC) < 0 ms
Number of Class 1 (CIP) connections 6