C3 Submersible Fluorometer
Table of Contents
1. Introduction
1.1 Introduction 4
1.2 Optical Sensors 4
1.3 Important Note Regarding the Use of the Fluorescein Sensor 5
2. Inspection and Setup
2.1 Instrument Checklist 6
2.2 Optional Accessories 7
2.3 Identification 9
3. C-Soft Windows™ User Interface
3.1 Software Installation and PC Requirements 10
3.1.1 Minimum PC Requirements 10
3.1.2 Software Installation 10
3.1.3 PC Software Interface 10
3.2 Software Operation 11
3.2.1 Settings Screen 11
3.2.2 Current Data and Calibration Screens 12
3.3 Calibration Procedures
3.3.1 Direct Concentration Calibration 15
3.3.2 Raw Fluorescence Calibration – Blank Subtracted 16
3.3.3 Raw Fluorescence Calibration 17
3.3.4 Depth Calibration (Optional Accessory) 17
3.4 Log Setup Screen 18
3.5 Enabling Data Output Ready State 19
3.6 Downloading and File Management 20
4 Maintenance and Warranty
4.1 Maintenance 21
4.1.1
Rinsing 21
4.1.2
Care for the Bulkhead Connector 21
4.2 Warranty Terms 21
4.3 Warranty Service 22
4.4 Out of Warranty Service 22
Appendices
A C3 Submersible Fluorometer Specifications 24
B C3 Submersible Fluorometer Recommended Practices 25
C C3 Submersible Fluorometer Wiring and Cable Guide 26
D Linear Range, Quenching and Temperature Considerations 28
E C-FINS Installation Guide 29
F Installing the Battery Bracket 33
G Connecting the Submersible Battery Pack 34
H Installing the Mechanical Wiper 35
I Installing the Flow Cap 36
J Using the Secondary Solid Standard 38
K C-Series Analog Adapter 40
L How to set up Hyperterminal for Digital (ASCII) Data Capture 43
To Next Page
Loading...