Turner Designs C3 - Optional Accessories

C3 Submersible Fluorometer
998-2300 Rev. H Page 7
Submersible BatterySubmersible Battery
2.2 Optional Accessories
♦ Pressure sensor (P/N: 2300-360) Factory-installed (Note: Can only be
installed during the manufacturing of the unit.)
♦ C3 Mechanical Wiper (P/N: 2300-450) Factory-installed (Note: Can only be
installed during the manufacturing of the unit.)
♦ Replacement Wiper Brushes (P/N: 2300-460)
♦ Replacement Wiper Spacers (P/N: 2300-462)
♦ Rechargeable Submersible Battery Pack including charger (P/N: 2200-601)
♦ Battery Bracket (P/N: 2300-603) (Note: Required for use with Battery
Pack and Analog Output Adaptor.)
♦ Flow Cap (P/N: 2300-700)
♦ Shade Cap (P/N: 2300-500) or C-ray Shade Cap (P/N 2300-502)
♦ Shade Cap Weight (P/N: 2300-510)
♦ C-ray Towed Deployment Body (P/N 2300-750)
♦ Extender Cables:
♦ 10 meters (P/N: 105-2595)
♦ 25 meters (P/N: 105-2596)
♦ 50 meters (P/N: 105-2597)
♦ Custom lengths available upon request
♦ Booster Kit (P/N: 2200-900) (Note: Required for cable lengths greater
than 10 meters.)
♦ 24” Pigtail Interface Cable with Locking Sleeve (2200-170)
♦ 24” Integration Cable (P/N: 2200-160) or 5m Integration Cable (P/N: 2200-
165) (Note: Used for continuous data output and communication with
the C3, NOT intended for uploading firmware to the C3.)
♦ Secondary solid standard (P/N: 2300-900) for multiple sensors (Note: Not
available for turbidity or ultraviolet sensors.)
♦ C-Series Analog Output Adapter (P/N: 2300-480)
Mechanical WiperMechanical Wiper