998-2300 Rev. H Page 27
C3 Integration Cable (P/N 2200-160
and 2200-165) This cable is identified
by the yellow band of heat shrink.
The integration cable is used to
connect the C3 to a PC or data logger
for continuous data capture. It
prevents interruptions in the C3 data
transmission to the PC.
C3 Interface Cable (P/N 2200-150)
This cable is included as a standard
accessory with the C3. It is used to
program and calibrate the C3 and
provide real-time data view. The
cable length is approximately 2.5’.
The cabled configuration allows for real-time data transmission. The C3
measurements are sent from the RS-232 cable to a PC where the fluorescence data
can be viewed and recorded on a computer or a data logger that can record digital
ASCII data. The data can also be saved on MS Excel from your C-Soft Software.
Computer Interface CableComputer Interface Cable
Computer Integration Cable
yellow heat shrink
Computer Integration Cable
yellow heat shrink
This is the +12VDC power supply P/N 159-0191.
It is included as a standard accessory with the C3.
The power supply connects to the +12 VDC
connector on the interface or integration cable
which will supply power to the C3.
In order to provide greater length, extender cables
P/N’s 105-2595 (10 M), 105-2596(25M) or 105-
2597(50 M) and custom cables up to (100M) can
be installed along with the boosters (P/N 2200-
900) here between the C3 and the interface cable
to allow the signal and power to travel greater
distances.
This is where + DC power is connected.
This is the RS-232 connection to the PC
This is the +12VDC power supply P/N 159-0191.
It is included as a standard accessory with the C3.
The power supply connects to the +12 VDC
connector on the interface or integration cable
which will supply power to the C3.
In order to provide greater length, extender cables
P/N’s 105-2595 (10 M), 105-2596(25M) or 105-
2597(50 M) and custom cables up to (100M) can
be installed along with the boosters (P/N 2200-
900) here between the C3 and the interface cable
to allow the signal and power to travel greater
distances.
This is where + DC power is connected.
This is the RS-232 connection to the PC
To Next Page
Loading...