Why is my Tuttnauer 3850E leaking at the door?
If your Tuttnauer Laboratory Equipment is leaking at the door, ensure the door is tightened enough and the door gasket is sealing the chamber. If necessary, replace the door gasket.
Why are wraps burned after using Tuttnauer 3850E?
To address wraps coming out burned from your Tuttnauer Laboratory Equipment, check if the water sensor is dirty. Also, verify that the wall outlet voltage is not too high and ensure items are not touching the chamber walls or bottom. Load the autoclave according to the instructions.
How to clean a very dirty Tuttnauer 3850E chamber?
To clean a very dirty chamber in your Tuttnauer Laboratory Equipment, use Chamber Brite ™. Very dirty machines may require two cleanings.
Why does Tuttnauer 3850E take so long to heat up?
If your Tuttnauer Laboratory Equipment takes too long to heat up, clean the air jet and check for proper voltage at the wall outlet.
What to do if spore tests fail in Tuttnauer 3850E?
If spore tests are failing or indicator strips are not turning in your Tuttnauer Laboratory Equipment, clean the air jet. Also, make sure the sterilization time and temperature are set correctly, and ensure the autoclave is not too heavily loaded.
Why does Tuttnauer Laboratory Equipment printer feed paper constantly?
If the printer on your Tuttnauer Laboratory Equipment gives paper feeds all the time when the machine is switched on, make sure the ‘feed button’ on the printer is not stuck.
How to troubleshoot Tuttnauer 3850E machine not responding?
If your Tuttnauer Laboratory Equipment machine isn't responding, verify that the main switch is in the ‘On’ position, the power cord is properly connected to both the machine and the mains, and the circuit breaker hasn't tripped. Also, check the reset button on the cut-out thermostat.
What to do if Tuttnauer 3850E process fails during heating stage with a HIGH TEMP message?
If your Tuttnauer Laboratory Equipment process fails while initiating the heating stage and displays a HIGH TEMP message, try changing the setting of the thermostat.
How to clean a very dirty chamber in my Tuttnauer 3850E?
If the chamber of your Tuttnauer Laboratory Equipment is very dirty, use Chamber Brite ™ to clean the autoclave; very dirty machines may require two cleanings.
What does ‘Low Heat’ mean on my Tuttnauer 3850E?
If the message ‘Low Heat’ is displayed during heat up on your Tuttnauer Laboratory Equipment, it indicates a bad temperature sensor. If heating elements are remaining on instead of cycling on and off, call for a technician.
Inspect the autoclave for damage upon arrival and document any findings.
Details warranty coverage, activation process, and repair procedures.
Provides electrical specifications and fuse/breaker ratings.
Details overall dimensions and physical specifications.
Details the purpose and operation of each key on the control panel.
Explains various messages and associated safety measures displayed by the unit.
Covers programs for unwrapped, wrapped items, glassware, and dry only.
Guides for first-time use, program selection, and starting a cycle.
Outlines daily, weekly, and periodic maintenance procedures.
Solutions for low heat, low water, low pressure, low temperature, and unresponsiveness.
General| Brand | Tuttnauer |
|---|---|
| Model | 3850E |
| Category | Laboratory Equipment |
| Language | English |
To Next Page
