Tuttnauer 3850E - User Manual

Other manuals for Tuttnauer 3850E

Technical Manual111 pages

Questions and Answers

J
Jennifer BenjaminSep 2, 2025
How to fix a Tuttnauer 3850E chamber that is not filling?
- A
  Alyssa WrightSep 2, 2025
  If the chamber of your Tuttnauer Laboratory Equipment is not filling, check the water level in the reservoir. Also, inspect the bottom of the reservoir for any obstruction blocking the pickup tube. Clean the water sensor and try filling the machine manually using the Manual Inlet key.
L
lisarodriguezSep 3, 2025
Why is the drying cycle taking so long in my Tuttnauer 3850E?
- J
  James ChaseSep 3, 2025
  If the drying cycle in your Tuttnauer Laboratory Equipment is taking too long, the autoclave may be overloaded. Also, consider replacing the HEPA filter.
I
itorresSep 4, 2025
Why does the exhaust stage take so long when running a cycle on my Tuttnauer 3850E?
- M
  Ms. Yolanda PhillipsSep 4, 2025
  If you are running a ‘glassware’ program on your Tuttnauer Laboratory Equipment, this is normal. The slow exhaust will take between 15 and 20 minutes.
C
chasecurtisSep 5, 2025
Why is there a loud noise coming from the reservoir of my Tuttnauer 3850E Laboratory Equipment?
- P
  piercelisaSep 5, 2025
  If there is a loud noise coming from the reservoir of your Tuttnauer Laboratory Equipment, the sterilization temperature might be set too high. The maximum setting is 274ºF (134ºC).
W
washingtonrebeccaSep 6, 2025
How do I fix a Tuttnauer 3850E printer that doesn't print?
- C
  Carlos BridgesSep 6, 2025
  If the printer of your Tuttnauer Laboratory Equipment does not print, ensure the paper is inserted in the printer. If the printer prints a test printout, the printer is O.K. and there is a problem with the electronics. Contact your dealer to solve the problem. If the printer does not print the test printout, there is a problem with the printer. Contact your dealer to solve the problem.