28
3. Start/ Stop key
This key commands the following 3 functions:
♦ Starting the process.
♦ Stopping the process.
♦ Canceling the FAIL message from the command panel
and opening the electric door locking if available.
Starting the process:
For starting a program this key is active only when the
autoclave is in the “Ready” mode. If the door is closed, the
water level in the reservoir is normal and the “Ready” indicator
is on the screen then pressing this key starts the selected
program.
Stopping the process:
For stopping a program this key is active while the autoclave is
running a program, pressing this key at any stage of the
program stops the process.
Canceling the FAIL message
At the end of an aborted program, the FAIL light is turned on
and an error message is displayed on the screen indicating the
cause of the failure.
Pressing this key cancels the displayed message and switches
off the FAIL light.
4. Program key
This key is designed for programming the date and time as well
as setting system parameters. The date and time settings are
readily available to the machine operator. System parameters
are only accessible with the appropriate access code and should
only be changed by a properly trained and qualified service
technician.
When the PROGRAM key is pressed, the first to be displayed
is the date with the cursor under the day. Each time the
PROGRAM key is pressed the cursor advances to the next
parameter, month, year, hour, minutes and then seconds. Using
the UP (5) and DOWN (6) keys will change the value of the
parameter above the cursor.
After the date and time have been set, pressing the PROGRAM
key again will show CODE: 000. A technician’s access code is
required to proceed further and change system parameters.
Information on all the system parameters can be found in the
Technicians Manual.
To Next Page
Loading...
