About this Manual
This manual is intended for trained service technician/personnel with hardware
knowledge of computers. Components inside the compartments should be serviced
only by a trained service technician/personnel. This manual is aimed to provide you
with instructions on installing your TYAN TS75-B8252.
How this guide is organized
This guide contains the following parts:
Chapter 1: Overview
This chapter provides an introduction to the TYAN TS75-B8252 barebones and
standard parts list, describes the external components, gives an overview of the
product from different angles.
Chapter 2: Setting Up
This chapter covers procedures on installing the memory modules, hard drivers and
other optional parts.
Chapter 3: Replacing the Pre-installed Components
This chapter covers the removal and replacement procedures for pre-installed
components.
Chapter4: BIOS Setup
This chapter describes the Hostboot menu program. The menu program lets you
modify basic configuration settings. The settings are then stored in a NVRAM
partition that retains the information even when the power is turned off.
Chapter 5: Installing GPU Card
This chapter introduce how to installing the GPU Card and list how many kinds GPU
Cards are suitable for TS75-B8252 chassis.
Appendix:
This chapter provides the cable connection table, how to install IO plate for OCP
Card, the FRU parts list for reference of system setup, and technical support in case
a problem arises with your system.
To Next Page
Loading...