EasyManua.ls Logo

TYPHOON Q500+ - Page 16

TYPHOON Q500+
37 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
WATCH ME FUNCTION
Watch Me funcon enables the camera to keep tracking the remote control-
ler no maer where and how it moves as the camera can automacally lt its
angle according to the controller. Usually, the default funcon under Smart
Mode is Follow Me. Watch Me funcon can be switched to by following
steps:
Switch to Watch Me:
1. Power on the TYPHOON and the ST10+.
2. Put the Proporonal Control Rate Slider in Rabbit posion, and then push
the Elevator Control Sck up to the end and hold it.
3. Toggle the Flight Mode Selecon Switch a couple of mes unl you hear
motor beep.
4. Release the Elevator Control Sck. Put the Flight Mode Selecon Switch in
Smart Mode.
5. Take off when you see the TYPHOON Main LED Status Indicator blinks
white every 3 seconds.
6. Once the TYPHOON is above 2m and out of Smart Circle, the TYPHOON
yaw direcon will take the control itself. the Camera lens will always point
to you as long as Flight Mode Selecon Switch is in Smart Mode.
7. Please note that you need to put the CGO2+ Pitch Angle/Posion Control
Slider in the middle posion. If you want to trim camera angle up, then just
move the Pitch Angle/Posion Control Slider a bit up. If you want to trim
camera angle down, just move the slider down.
Switch Back to Follow Me:
1. Land the TYPHOON and shut the motors.
2. Put Proporonal Control Rate Slider on Rabbit posion, then push Aileron
Control Sck le to the end and hold.
3. Toggle Flight Mode Selecon Switch a couple of mes unl you hear
motor beeps.
4. Release Aileron Control Sck. Put Flight Mode Selecon Switch in Smart
Mode.
5. Take off when you see TYPHOON Main LED Status Indicator blinks white
every 3 seconds.
Warning: Keep in mind that the aircra will maintain a constant altude and
can not detect obstacles. It is not recommended to change pilot’s altude in
Watching Me funcon.
15
System Setting
Flight Setting
Model Select
MODE
SMART TRANSMITTER ST10 WELCOMEPILOT 11:25:11am
N/A
GPS
N/A
STA
N/A
POS
N/A E
N/A N
VOLTS
N/A V
ALT
N/A ft
G-SPD
N/A mph
DIS
N/A ft
In Watch Me funcon, the pilot will always be kept in the frame wherever
he moves.

Related product manuals