TYPHOON Q500+ - Flying

Step 5) Step back approximately 26 feet (8 meters) behind TYPHOON.
Flying
TAKEOFF
To takeoff, slowly raise the le-hand sck to slightly above the center
posion. TYPHOON will takeoff and climb slowly (or raise the sck further
unl it does). Allow the sck to return to the center posion when
TYPHOON reaches the desired altude.
FLYING
Take your me learning how TYPHOON responds to various control inputs
while flying. In Smart Mode TYPHOON will always move in the direcon
the right-hand control sck is pushed relave to the pilot and no maer
which way the front/nose is pointed. In Angle (Pilot) Mode TYPHOON will
move in the direcon the control sck is pushed relave to the front/nose
of the aircra (and the ‘angle’ of movement is determined by how far you
push the sck away from the center posion). And please see the
corresponding secons of this instrucon manual for more informaon on
Smart Mode and Angle (Pilot) Mode.
IMPORTANT NOTE: If at any me during flight you feel like TYPHOON is
driing out of/beyond your control, simply release both control scks.
TYPHOON will automacally self-level and will even hold its posion (with
a suitable GPS signal/lock) when both control scks are centered. You can
also acvate Home Mode so TYPHOON automacally flies itself back to
the home point and lands.
LANDING
There are two ways to land TYPHOON:
1) Posion TYPHOON above the area where you would like to land. Slowly
lower the le-hand sck to below the center posion. TYPHOON will
descend slowly and land. Aer TYPHOON lands, press and hold the red
START/STOP buon for approximately two (2) seconds to stop the motors.
2) Acvate Home Mode and TYPHOON will automacally fly itself back to
the home point and will land within a 10 foot (3 meter) diameter circle
around it.
WARNING: Always land as soon as possible aer the first level low voltage
baery warning, or land immediately aer the second level low voltage
baery warning (as indicated by the vibraons and audible alerts from the
ST10+, and by the Below Motor LED Status Indicators flashing rapidly). And
if at any me the Aircra Baery Voltage shown on the screen is below
10.7V, land TYPHOON immediately.
AFTER LANDING
ALWAYS turn off TYPHOON BEFORE turning off the ST10+. Then remove
the baery from TYPHOON and allow it to cool to ambient/room tempera-
ture before recharging.
WARNING: Do not aempt to operate TYPHOON in
winds that exceed 8–12 miles per hour (13–19 kilometers
per hour).
Step 6) Press and hold the red
START/STOP buon for approxi-
mately three (3) seconds to start the
motors. Or you can lower the
le-hand sck all the way, move it all
the way to the le, then all the way to
the right and back to the middle to
start the motors.
23