TYPHOON Q500+ - Disabling GPS; Graphical User Interface

Step 2) Move the right-hand sck all the way to the right and hold it there
unl step 3 is completed.
Step 3) Move the Flight Mode Selecon Switch from Smart to Home and
Home to Smart mode 4 mes in 3 seconds.
When GPS has been disabled successfully TYPHOON will emit an audible
indicaon and the GPS status on the ST10+ screen will show ‘Disabled’.
Also, the Main LED Status Indicator will flash purple and the Below Motor
LED Status Indicators will flash three (3) mes per second then will stay off
for one (1) second.
WARNING: Do NOT leave the ST10+ and TYPHOON powered on and do
NOT leave the flight baery installed in TYPHOON as doing so can over-dis-
charge and damage the baeries. Over-discharging can cause damage to the
baeries resulng in reduced performance or failure of the baeries enrely.
IMPORTANT NOTE: Baery damage, crash damage and ‘fly aways’ are
NOT covered under warranty.
Disabling GPS
WARNING: Smart Mode and Home Mode, along with their corresponding
features, only work when GPS is acve and TYPHOON has a suitable GPS
signal/lock. If you disable/turn off GPS TYPHOON can only be flown in
Angle (Pilot) Mode. And if you cannot properly control TYPHOON in Angle
(Pilot) Mode the aircra may crash or even ‘fly away’.
IMPORTANT NOTE: Crash damage and ‘fly aways’ are NOT covered under
warranty.
We do not typically recommend disabling GPS for any reason, especially if
you’re a first-me or low-me pilot. However, if you’re an experienced
pilot that’s able to properly control TYPHOON in Angle (Pilot) Mode, and
you do not exceed any altude/distance limits or fly in any ‘no fly zones’ in
your area, you can disable/turn off GPS. And do NOT disable/turn off GPS
unless you accept ALL responsibility and liability for crashes or ‘fly aways’.
IMPORTANT NOTE: Every me you turn TYPHOON on it will default to
having GPS acve/on (even if you disabled GPS the last me is was
powered on).
Step 1) While the ST10+ and TYPHOON are powered on and linked (and
the motors are NOT running), move the Proporonal Control Rate Slider on
the right side of the ST10+ to the uppermost (rabbit) posion.
Graphical User Interface (GUI)
You can download the graphical user interface (GUI) soware on
TYPHOON product page at www.Yuneec.com. Follow the on-screen
instrucons to install and operate the soware which allows you to see the
status of all sensors, to adjust various sengs, check GPS accuracy, update
firmware and more using the included USB Interface/Programmer.
24