TYPHOON Q500+ - Page 37

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits
are designed to provide reasonable protecon against harmful interference in a residenal installaon. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instrucons, may cause harmful interference to radio communicaons. However,
there is no guarantee that interference will not occur in a parcular installaon. If this equipment does cause harmful interference to radio or television
recepon, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
—Reorient or relocate the receiving antenna.
—Increase the separaon between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.
CAUTION: Changes or modificaons not expressly approved by the party responsible for compliance could void the user’s authority to operate the
equipment.
This product contains a radio transmier with wireless technology which has been tested and found to be compliant with the applicable regulaons govern-
ing a radio transmier in the 2.400GHz to 2.4835GHz frequency range.
Antenna Separaon Distance:
Maintain a separaon distance of at least 2 in (50mm) between your body (not including your fingers, hands and wrists) and the antennas to meet the RF
exposure safety requirements determined by FCC regulaons.
RF Exposure Warning
This equipment must be installed and operated in accordance with provided instrucons and the antenna(s) used for this transmier must be installed to
provide a separaon distance of at least 20 cm from all persons and must not be co-located or operang in conjuncon with any other antenna or transmit-
ter. End-users and installers must be provide with antenna installaon instrucons and transmier operang condions for sasfying RF exposure compli-
ance.
IC Radiaon Exposure Statement for Canada
This device complies with Industry Canada licence-exempt RSS standard(s).
Operaon is subject to the following two condions: (1) this device may not cause interference, and (2) this device must accept any interference, including
interference that may cause undesired operaon of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence. L'exploitaon est autorisée aux deux
condions suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2) l'ulisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même
si le brouillage est suscepble d'en compromere le fonconnement.
36