C099-F9P - User Guide
UBX-18055649 - R02 Firmware updates Page 31 of 48
• Select the COM port installed for the ODIN-W2.
• Set the baud rate to 460800 baud.
• Ensure there is no hardware flow control enabled.
• Click on the FTDI USB Latency Timer Update button.
• Click Open Port.
• The ODIN-W2 should respond with AT commands in the Console Window:
Figure 48: s-center connected to ODIN-W2
Select “Tools > Firmware Update…”
Figure 49: s-center Tools > Firmware Update selection
To Next Page
Loading...