UCOM COCOON 1100 - Removing a Handset; Selecting a Base Unit

24 Cocoon 1100
Cocoon 1100
• Press to confirm.
•Select ‘Register’ and press .
• Select a base (‘1’-’4’) with the up and down keys
/ and press .
• Enter the system PIN code (base PIN code; default=’0000’) and press .
• The handset will now search for a base and register when found. The standby screen
will appear when successfully registered and handset name and number will be shown.
13.2 Removing a handset
It is possible to cancel subscription of a handset to a base. You should do this if a handset is
damaged and has to be replaced by a new one.
• Press the left menu key under .
• Press the up or down key
/ repeatedly until ‘Handset’ is selected.
• Press to confirm.
• Press the up or down key / repeatedly until ‘Registration’ is selected.
• Press to confirm.
•Select ‘De-register’ and press .
• Enter the system PIN code (base PIN code; default=’0000’) and press
.
• Select a handset you wish to remove by pressing the numerical keys (‘1’-’4’).
• Press the OK key
to remove.
13.3 Selecting a base unit
If your handset is subscribed to several base unit stations (max. 4), you must select a base
unit because the handset can only communicate with one base unit at a time. There are two
possibilities:
13.3.1 Automatic selection
If you set the handset to ‘automatic selection’, the handset will automatically choose the
closest base unit in standby:
• Press the left menu key under .
• Press the up or down key
/ repeatedly until ‘Handset’ is selected.
• Press to confirm.
• Press the up or down key / repeatedly until ‘Select Base’ is selected.
• Press to confirm.
•Select ‘Auto’ and press to confirm.
Each handset can be subscribed to 4 different DECT base units. Each
base unit is assigned a number from ‘1’ to ‘4’ in the handset. When
you subscribe a new handset, you can assign a base unit number. It
is best to use ‘1’.
You can only cancel subscription of another handset, not the
handset you are using to do the remove procedure.
When you have activated Automatic base selection and the handset is
out of range on the current base, the handset will only search for the
strongest base in standby (not during communication).
2
2
3
10
2
2
15
3
10
2
3
10
2
2
2
OK
11
15
3
10
2
3
10
2
2