20
Technical data
13 Technical data
Cannot dial a number Wrong dialling mode see "6.12 Setting the dialling
mode" to set the correct
dialling mode
The symbol is flashing
Handset is out of range Move closer to the base
station with the handset
The base station has no power Check the mains adapter and
cable
The handset is not logged onto
the base station
Log the handset onto the base
station
The base station or handset
does not ring
The ring tone volume is off or
too low
Adjust the ring tone volume
A call cannot be forwarded to
an extension
The Flash time is too short Set the device to a long Flash
time
Telephone does not respond
when keys are pressed
Operating error Remove the batteries and then
insert them again
Range up to 300 m outdoors
up to 50 m indoors
Handset batteries: 2 x 1.2V, 600mAh AAA type rechargeable NiMh
Base station power supply 220/230V / 50 Hz
Handset standby 100 hours in standby mode
Handset talk time 11 hours
Permitted operating
temperatures
+5 °C to +45 °C
Permitted relative humidity 25 to 85%
Dialling mode Pulse dialling and tone dialling (DTMF)
Number memory handset 50 phonebook entries of up to 24 digits and 14 characters
Number memory corded
telephone
3 direct memory dial numbers (M1-M3) of up to 16 digits
10 indirect memory dial numbers - Memory numbers 0-9
Dimensions Base station /
Charger / Handset
210 mm x 62 mm x 160 mm / 75 mm x 45 mm x 76 mm /
163 mm x 30 mm x 57 mm
Weight Base station /
Charger / Handset
831 g with mains adapter / 200 g with mains adapter /
144 g with batteries
Fault Possible cause Solution
To Next Page
Loading...