Ultimaker 2+ Manual

Ver. 01NL okt19
2
MAKERS LAB
Benno Premselahuis
Rhijnspoorplein 1
1091
GC Amsterdam
Contents
Begin 3D printing .......................................................................................................... 3
Removing and introducing material ............................................................................... 4
Introducing material ...................................................................................................... 9
Preparing build plate ................................................................................................... 12
Preparing 3D print in Cura 4.2.1 ................................................................................. 13
Begin printing .............................................................................................................. 17
3D print ready ............................................................................................................. 18

Ultimaker 2+ Specifications

General

Build Volume	223 x 223 x 205 mm
Layer Resolution	20 - 200 microns
Print Technology	Fused Filament Fabrication (FFF)
Filament Diameter	2.85 mm
Print Speed	30 - 300 mm/s
Connectivity	USB, SD Card
Weight	11.3 kg
Nozzle Diameter	0.4 mm
Supported Materials	PLA, ABS, CPE
Display	LCD
Software	Cura
Power Supply	100 - 240 VAC, 50 - 60 Hz
Operating Temperature	15 - 32 °C
Dimensions	342 x 588 mm