Ultimaker 2+ - Begin 3 D printing

Ver. 01NL okt19
3
MAKERS LAB
Benno Premselahuis
Rhijnspoorplein 1
1091
GC Amsterdam
Begin 3D printing
The manual is based on Cura version 4.2.1.
There is already material
in the printer and I will be
printing with this material.
Continue on page 12.
There is no material in the
printer.
Continue on
page 9.
There is already material
in the printer, but I will not
be printing with this
material.
Continue on
page 4.
There is already material
in the printer and I want to
remove it.
Continue on
page 4.