Ultimaker S5 Pro Bundle - Table of Contents

Ultimaker S5 Pro Bundle user manual 1
Table of contents
1. Safety and compliance
1.1 Safety messages 5
1.2 General safety information 5
1.3 Hazards 5
1.4 Health and safety 7
2. Introduction
2.1 Main components 9
2.2 Specications 12
3. Installation
3.1 Unboxing 14
3.3 Hardware installation 16
3.4 Welcome setup 17
3.5 Firmware update 19
3.6 Install Ultimaker Cura 19
3.7 External ventilation (optional) 19
4. Operation
4.1 Touchscreen 21
4.2 Materials 21
4.3 Preparing a print with Ultimaker Cura 23
4.4 Remove the print 25
4.5 Remove support material 26
4.6 Change the printer conguration 27
4.7 Calibration 28
4.8 Uninstalling the Air Manager 30
4.9 Humidity control 30
5. Maintenance
5.1 Update the rmware 32
5.2 Material handling and storage 32
5.4 Clean the Ultimaker S5, Air Manager and Material Station 33
5.6 Check for play on the axles 36
5.7 Check the tension of the short belts 36
5.8 Check for debris in the front fan of the print head 37
5.9 Check the quality of the nozzle cover 37
5.10 Lubricate the lead screw of the Z motor 38
5.11 Clean the feeders 39
5.12 Clean the print cores 39
5.13 Lubricate the feeder gear 41
5.14 Replace the Bowden tubes 41
5.15 Clean the fans 42
5.16 Lubricate the hinges 42
5.17 Replace the Air Manager lter 42