Ultimaker S5 Pro Bundle - Update the Firmware

Ultimaker S5 Pro Bundle user manual 32
5.1 Update the rmware
Periodically, a new version of the Ultimaker S5 Pro Bundle rmware is released. To ensure that your Ultimaker
S5 Pro Bundle is equipped with the latest features it is recommended to keep the rmware updated
to the latest version.
Updates for the Material Station and Air Manager are automatically installed alongside the newest
Ultimaker S5 rmware.
Update your Ultimaker via the network
If the Ultimaker S5 Pro Bundle is connected to a network, it automatically checks for available rmware updates.
When a new rmware is available, the printer will prompt you to download and install it via the touchscreen
interface. Alternatively, check for updates manually by navigating to System → Maintenance → Update rmware.
Do not power o the printer during the rmware installation.
Update your Ultimaker via USB
If your Ultimaker S5 Pro Bundle is not connected to a network, you can update to the latest rmware via USB. The
rmware les are found on the Ultimaker website:
1. Navigate to ultimaker.com/rmware, and select Ultimaker S5
2. Download the rmware image and store it in the root directory of your USB stick
3. Insert the USB stick into the USB port of the Ultimaker S5
4. Go to Preferences → Maintenance → Update rmware and select the new rmware in the update menu
5.2 Material handling and storage
The optimal storage temperature for PLA, Tough PLA, Nylon, CPE, CPE+, PC, TPU 95A, PP and Breakaway is between
-20 to +30 °C. For ABS the advised temperature is between 15 and 25 °C, and for PVA 0 to 30 °C. Furthermore,
a relative humidity of below 50% is recommended for PVA, TPU 95A, PP and Breakaway. If these materials are
exposed to a higher humidity the quality, of the material can be aected.
The Material Station can be used to store up to six spools of material. As long as the Material Station receives
power, the intelligent atmospheric management keeps the relative humidity below 40%. This means opened spools
can be safely stored in the Material Station.
Keep the door of the Material Station closed to enable optimal humidity control.
Additional opened spools of material must be stored in proper conditions. If material is stored incorrectly, it may
aect its quality and usability. To keep your materials in optimal condition, store them:
• Out of direct sunlight
• In a resealable bag
To minimize moisture absorption, store the material in a resealable bag, including the supplied desiccant (silica gel)
directly after unloading the spool from the Material Station.