Ultimaker S5 Pro Bundle - Page 23

Ultimaker S5 Pro Bundle user manual 22
Print recommendations
Each material requires dierent settings for optimal results. If you use Ultimaker Cura to prepare your model, these
settings are automatically set correctly if the correct print core(s) and material(s) are selected.
It is recommended to apply a thin layer of glue (using the glue stick from the accessory box) or an adhesion sheet
to the glass build plate before starting a print. This will ensure that your print adheres reliably to the build plate,
and also prevents the glass build plate from chipping when removing materials.
For detailed instructions on which settings and adhesion method to use per material, take a look at the material
manuals on the Ultimaker website.
To benet from the automatic material switching during a print when a spool runs out, it is recommended to have
at least two spools of the same material loaded into the Material Station.