Ultimaker S5 Pro Bundle - Page 44

Ultimaker S5 Pro Bundle user manual 43
1. Open the Air Manager and wait for the printer to prepare the lter replacement procedure
2. Take out the used lter by pulling the tab on the lter towards you and removing it from the lter housing
3. Directly place the used lter in a (resealable) bag and close it
4. Insert the replacement lter into the lter housing and gently push it. Select Conrm when the
lter is completely ush
5. Close the Air Manager to nish the placement and select Finish when done
If the lter is not replaced according to the above procedure, the lter usage counter will not be reset.
Never replace the lter while the Ultimaker S5 is in operation or if the Air Manager fan is spinning.
The lter in the sealed bag can be disposed of with your regular household waste.