UXPW 125 ENGINE SERVICE MANUAL AND EFI DIAGNOSTIC
- 59 -
6.5.5. Partial assembly of right cover
6.5.5.1.
Replace oil seal of control arm with new
one. Apply appropriate amount of lube
oil onto lever of control arm, then
install the arm into right cover.
6.5.5.2.
Use tools to knock cotter pin into
corresponding hole of control arm
.
6.5.5.3.
Rotate control arm, so that spring falls
into position as shown in figure. Then
install pushing rod of clutch
.
To Next Page
Loading...
