Need help?Do you have a question about the um CBF 125 and is the answer not in the manual?
Covers model, type, bore, stroke, displacement, compression, valve timing, power, torque, idle speed.
Details engine oil capacity and spark plug specifications.
Specs for valve clearance, stem diameter, and rocker arm components.
Covers cylinder bore dimensions and piston/ring clearances.
Details clutch and gear specifications like thickness and diameters.
Covers maintenance cycle, standards, and torque values.
Explains spark plug inspection, gap adjustment, and replacement.
Step-by-step instructions for adjusting valve clearance.
Describes how to check the engine oil level correctly.
Outlines the steps for draining and refilling engine oil and replacing the filter.
A detailed diagram illustrating the lubrication system's flow.
Technical specifications and common issues with remedies.
Step-by-step guide for removing and installing the oil pump.
Illustrated breakdown of cylinder head components for identification.
Procedures for disassembly and maintenance of the upper cylinder head cover.
Instructions for disassembling, inspecting, and assembling the rocker arm set.
Steps for disassembling and reassembling the cylinder head components.
Guide for removing and reinstalling the chain tensioner device.
Diagram showing the cylinder block and piston assembly.
Wear limits and common problems for cylinder and piston components.
Procedures for taking apart and inspecting the cylinder block and piston.
Illustrated breakdown of components for these systems.
Technical specifications, tightening torques, and common issues.
Step-by-step guide for removing and reinstalling the right engine cover.
Procedures for clutch extraction, inspection, and reassembly.
Instructions for servicing the gearshift arm and drive gear components.
Diagram of components for left cover, starting motor, and magneto.
Steps for removing and reinstalling the left engine cover.
Procedures for extracting and installing the starting motor system.
Guide for magneto stator removal and installation.
Diagram showing crankshaft and related components.
Technical data for crankshaft and drivetrain parts like shafts and gears.
Detailed steps for removing the crankshaft from the crankcase.
Procedures for removing and inspecting drivetrain components like shafts and gears.
Steps for safely removing and installing bearings.
Guide for reassembling the drivetrain components.
Procedures for measuring crankshaft runout and rod clearance.
Steps for reassembling the crankcase halves and related parts.
Overview of the EFI system and important safety guidelines.
Information on required diagnostic tools and common error codes with troubleshooting steps.
Guidance for troubleshooting based on specific motorcycle performance problems.
To Next Page
General
