UXPW 125 ENGINE SERVICE MANUAL AND EFI DIAGNOSTIC
- 67 -
6.6.3.5. Assemble gaskets and nuts. Apply
appropriate amount of engine oil
onto end face of nut
6.6.3.6. Use tools to fix pressure plate and
tighten locknut of clutch. Tightening
torque shall meet specified
requirement
Tightening torque: 74N.m
6.6.3.7. Assemble spring and clutch end
cover, and tighten bolts on the end
cover in sequence
6.7. GEARSHIFT ARM
(EXTRACTION AND INSTALLATION)
6.7.1. Take out gearshift arm components
Note: Do not fall washer into
crankcase.
To Next Page
Loading...
