UMD NVR User Manual
64
6. Web Client
6.1 Introduction
NVR supports to land and manage the device through web pages at the PC side.
Web Client systems provide network settings, the basic configuration, user
management, advanced configuration management, real-time preview, playback, download
and IPC management application modules.
6.2 System Log
6.2.1 Network connection
1, to ensure NVR proper access network
2, set IP address subnet mask and gateway for the NVR and the host computer need to
log NVR, NVR factory default IP address is 192.168.1.188.
3, detect either the network is properly connected via PING command.
6.2.2 WEB operation
1. Open the IE browser, enter the IP address of the NVR to log in the address bar, and
press Enter to load the login screen.
2, when you log in the system, you are prompted to accept the load WEB controls, if the
user chooses to accept, the system will automatically recognize the installation of the
control. In case of the control system from loading, make sure to install the other prohibited
controls to download plug-ins, and appropriate to reduce the IE security level.
To Next Page
Loading...
General