UTG2000B Series 103
3.3.4 Phase of Burst
Phase of pulse train is phase at starting point of pulse train. It is in the range of 0°~+360°. The
default initial phase is 0°. To change it, you can use multi-functional knob and direction key on the
interface for selecting type of pulse train or press soft function key
Param →
Phase .
● For sine wave, square wave, ramp wave and pulse wave, 0° is the point at which the waveform
passes 0V (or DC offset value) in forward direction.
● For arbitrary waveform, 0° is the first waveform point downloaded to the storage.
● Initial phase has no effect on the noise wave.
3.3.5 Period of Burst
Figure 3 -51 Set period of pulse train
Burst period (period of pulse train) is only applicable to N cycle mode, and is defined as the time
from one pulse train to the next pulse train. When trigger source is external or manual, burst period
To Next Page
Loading...
Need help?
General
