UTG2000B Series 11
● Setting amplitude>100mVpp, input voltage>±12.0V, frequency <10 kHz.
● Setting amplitude≤100mVpp, input voltage>±2.0V, frequency <10 kHz. “Overload protection,
output off” appears when the protection is valid.
2.3.2 Rear Panel
The rear panel is shown in figure 2-2:
1. External analog modulation input connector
2. External digital modulation/ frequency meter connector
3. LAN port
4. USB port
5. External 10MHz input connector
6. Internal 10MHz output connector
7. Ventilation vent
8. Fuse
9. Power switch
10. AC power supply
2.3.3 Function Interface
Function interface is shown in figure 2-3:
To Next Page
Loading...
