18 UTG2000B Series
18 types of operational functions are supported in this instrument. Expression enter into the expression
editing interface, press Next to cycle switch operational symbol or expression. For example, input
(x-1)*x(x+1), the interface is as below:
The default initial value is 0°, end value is 180°, and expression is sin(x). The unit can be in rad or °. The
setup procedures are as following:
Press Menu→Waveform→Type→Expression→Parameter in this order (Type is only accessible when it
is shown in Grey), press the variable button, input value and select the unit.
To Next Page
Loading...
