UTG2000B Series 31
After setting carrier wave parameter, press Return soft key to back to the following interface for
setting modulation depth.
Press Param →
depth soft key again, then enter number 80 and press % soft key with number
keyboard for setting modulation depth.
Enable Channel Output
Press CH1 button start channel 1 output quickly. Or enable output by pressing Utility and then
CH1 Setting . After channel output is opened, backlight of CH1 button is on, and on the right
side of channel information label, the font “OFF” changes to “AM”, meaning open channel output.
To Next Page
Loading...
Need help?
General
