38 UTG2000B Series
After setting carrier wave parameter, press Return soft key to back to the following interface for
setting frequency deviation.
Press Param →
FreDev soft key, then enter number 5 and press kHz soft key with number
keyboard for setting frequency deviation.
Press CH1 button start channel 1 output quickly. Or enable output by pressing Utility and then CH1
Setting . After channel output is opened, backlight of CH1 button is on, and on the right side of
channel information label, the font “OFF” changes to “FM”, meaning open channel
1 output.
To Next Page
Loading...
Need help?
General
