[15] INSTALLING THE PHONE
www.uniden.com
Wall Mounting the Base
This phone can be mounted on any standard wall plate.
1) Remove the wall mount adapter from the base and snap it
into the notches on the bottom of the base.
2) Plug the AC adapter to the DC IN 9V jack.
CAUTION: To avoid risk of fire and shock, only use the
Uniden AD-1007 AC adapter.
3) Route the AC adapter cord inside the molded wiring channel as
shown.
4) Plug the AC adapter into a standard 120V AC wall outlet.
5) Plug the telephone cord into the phone jack.
6) Route the telephone cord inside the molded wiring channel as
shown.
7) Plug the telephone cord into the telephone outlet.
8) Align the mounting slots on the base with the mounting posts on
the wall. Then push in and down until he phone is firmly seated.
9) On the base unit, pull the handset retainer out of the slot.
Rotate it clockwise 180 degrees.
10)Flip the retainer from front to back. Slide it back into the slot
so that the lip of the retainer is up and the oval is down. The
retainer holds the handset in place.
INSTALLING THE PHONE
To Next Page
Loading...
Need help?
General
