MAINTENANCE [56]
www.uniden.com
Warning: To avoid the risk of personal injury or property damage from fire or electrical shock, only
use the Uniden battery model and Uniden adapter model specifically designated for this product.
Caution:
• Use only the specified Uniden battery pack (BT-905).
• Do not remove the batteries from the handset to charge it.
• Never throw the battery into a fire, disassemble, or heat it.
• Do not remove or damage the battery casing.
Installing the Rechargeable Battery for Cordless Handset
1) Press down on the cordless handset battery case
cover (use the finger indention for a better grip) and
slide the cover downward to remove.
2) Plug the battery pack connector (red & black wires)
into the jack inside the battery compartment. (The
connector notches fit into the grooves of the jack only
one way.) Match the wire colors to the polarity label
in the battery compartment, connect the battery and
listen for a click to insure connection.
3) Make sure you have a good connection by slightly
pulling on the battery wires. If the connection is
secure, the battery jack will remain in place.
4) Place the battery case cover back on the handset
and slide it upwards until it clicks into place.
Note: Use only the Uniden BT-905 rechargeable battery pack supplied with your cordless telephone.
MAINTENANCE
To Next Page
Loading...
Need help?
General
