25
Setting Up the Phonebook
Each handset has its own separate phonebook that holds up to seventy names and numbers. When a handset’s
phonebook is full, the handset beeps and shows
Memory Full on the display. You cannot add any names and
numbers in that handset’s phonebook until you delete some of the existing ones.
You can also use the phonebook entries to store a group of numbers (up to twenty digits) that you may need to enter
once your call connects. This is referred to as chain dialing. (See Chain dialing from the phonebook on
page 32.)
Creating Phonebook Entries
To store names and numbers in your phonebook, please follow these steps:
With the phone in standby, press
(on the left side of the four-way key).
To create a new phonebook entry, press MENU/SELECT. Select the Create
New menu. Edit Name appears.
Enter the name for this entry (EDIT NAME).
Use the keypad to enter a name for this entry; the name can contain up to sixteen characters. (See Entering
Text from Your Handset on
page 22 for instructions on entering text.) If you do not want to enter a name for this
entry, your phone will store this entry as
No Name. Press MENU/SELECT when you are nished.
Enter the number for this entry (EDIT NUMBER).
Once you have stored a name,
Edit Number appears next. Use the number
keypad to enter the phone number; the phone number can contain up to
twenty digits. If you need the phone to pause between digits when it’s dialing
(for example, to enter an extension or an access code), press REDIAL/
PAUSE to insert a two-second pause. You will see a
P in the display. You can
also use more than one pause together if two seconds is not long enough.
Each pause counts as one digit. Press MENU/SELECT when you are
nished.
1)
2)
3)
4)
To Next Page
Loading...
Need help?
General
